*
Chrysler 4.0L engine

*
Make certain the oil filter comes through a gasket!
Get her motor oil. The warranty requires 10W-30 that meets Chrysler MS-6395. This Chrysler spec will be posted on the ago of the bottle. Many oil brands fulfill this requirement. A notable exemption is Mobil oil. I believe this is as result of lack of gaining the spec from Chrysler an ext than no being compliant. If your engine is still on warranty, make sure you usage the exactly stuff. This is no a high power engine. Typical oil is good enough; the engine virtually always outlasts the rest of the vehicle!Get your oil filter. I generally use Purolater PureOne filters. Have actually a save associate look the the correct model. Note: Make certain that there is a gasket top top the filter!Warm the engine. Journey it a couple miles so the oil is nice and also hot.Park the valve on a level surface. Before shutting off the engine, rotate the steering wheel all the way to the appropriate to ease access to the oil drain bolt.From the passenger side, place on the floor in former of the tire. Looking increase you should see the oil pan.

You are watching: 2010 chrysler town and country oil capacity

*
View from passenger-side.
*
Oil drainpipe bolt o left. Oil filter top top right.
Place oil catch pan under the bolt.Loosen the oil drain plug by transforming counter-clockwise utilizing a 13-mm socket and wrench. I typically grab mine torque wrench simply due to the fact that the added length boosts the torque i can apply to the bolt.Once the loose, slowly turn while maintaining pressure on the bolt therefore the warm oil remains in the engine"s oil pan. Once you deserve to tell its prepared to come out, quickly remove the bolt. The oil will be hot! Also, don"t drop the bolt into the oil pan. That is no funny fishing it out of warm motor oil.Pop open the hood. The hood relax is ~ above the dash near the driver"s left knee.Unscrew counter-clockwise the engine"s oil cap. The is easily identified with a snapshot of an oil can and also 10W-30 printed on it. Removing this lid will rise the speed at i beg your pardon the hot oil exit the engine. Make sure oil is still draining right into the record pan and not overshooting it!Wait until the oil just drips the end of the oil pan.Move the oil capture pan so the can get oil from the drain bolt hole and also the oil filter.Put a cap-style oil filter onto her wrench.
*
Cap-style oil filter remover ~ above wrench.
Place the cap onto the oil filter. Revolve counter-clockwise to remove. When its fully removed, it will dump hot oil. Make sure your capture pan is placed accordingly.Make certain the old oil filter still has actually the gasket attached to it. If its no there, it can be grounding to the engine. Remove it! If you don"t, girlfriend will have a major oil leak later! i have changed oil because that 25 years and also this van to be the very first that ever before had the gasket stick come it. That was easily removed after i wasted about 4 quarts the oil.Wait for all oil come drip native the engine. This will take around 20 minutes.Screw the bolt back into the engine block by hand. Usage your socket and also wrench to further tighen it. Carry out not over-tighten! usage a torque wrench to it is in sure. Note: The oil bolt contains a gasket. View the diagrams below:
*
Correct placement of gasket on oil bolt.

See more: How Many Valence Electrons Do The Alkali Metals Possess, Do Alkali Metals Have 1 Valence Electron

*
Incorrect placement of gasket on oil bolt.This needs pushed down right into the seat.
Using her finger, smear oil top top the oil filter gasket. This will ensure a great seal.Put the oil filter top top the oil filter obelisk as tight together you have the right to using your hands. You may use a torque wrench to make sure its on tight enough. Generally, I simply make it together tight by hand together possible.Place a funnel into the oil filler place in the engine compartment.Add 5.5 quarts the oil.Put oil filler cap ago in place.Fire increase the engine and also make sure the oil pressure light goes out. If that doesn"t, shut off the engine immediately. Something is wrong. Top a auto guy!If there are any type of leaks, tighten the bolt or filter.This Chrysler engine is odd. That takes mine an entire evening for every the oil to drainpipe into the oil pan. Do a precursory check now to make certain its in ~ spec ~ above the dipstick. Include if necessary. Check a 2nd time in the morning!
Posted byBP Wrightat1:20 PM
*