How countless qts of trans fluid, there is no draining the converter. Walk a 2003 ford traveler 4.0 6 cyl take?


You are watching: 2005 ford explorer transmission fluid capacity

*

liquid CAPACITIESNOTE: Capacities offered are approximate. Correct fluid level should be identified by fluid level check procedure, rather than lot of fluid added. As a rule of thumb between 5 and also 6 qts. Yet you must stat checking the fluid at 4 1/2 quarts. This overview should help you outhttps://www.civicpride-kusatsu.net/articles/how-to-service-an-automatic-transmissionRefillingTo install fluid pan, gasket and filter, turning back removal procedures. View Fig. 9 and Fig. 10 .Hold the larger drainpipe plug with a wrench and also remove the little (center) liquid level describe plug using a 3/16" Allen key. Download the liquid Level & fill Plug Adapter (307-437) right into the pan. See Fig. 4 .Prior to pour it until it is full the fluid Transporter/Evacuator/Injector (307-D465) through clean transmission fluid, make sure that the canister is clean. Check out Fig. 5 . Fill the distinct tool with clean automatic infection fluid. Hang the fluid transporter/evacuator/injector under the vehicle, upright and also close come the transmission.Connect the open end of the fluid hose native the fluid transporter/evacuator/injector to the liquid level and fill plug adapter at the bottom that the transmission liquid pan. Check out Fig. 6 .Apply a maximum of 30 psi (206.85 kPa) come the open end of the vacuum/pressure water tap from the Rubber tip Air Nozzle (100-D009). View Fig. 7 . Fluid will immediately start flowing the end of the distinct tool into the transmission liquid pan.Add 2 or 3 quarts that transmission fluid into the fluid pan. Stop the procedure by releasing the waiting pressure and removing the wait nozzle from the finish of the hose. Engine idle speed is about 650 RPM. Start and run the engine until the transmission liquid temperature is in between 80-120 F (27-49 C).Inspect the fluid level in the unique tool. If the liquid drains ago into the canister, the transmission is full. If no fluid drains back, more fluid will have to be added. Repeat actions 6 and also 7 .Once the transmission is full, ar a hand vacuum pump top top the open finish of the vacuum/pressure hose of the Vacuum Pump Kit (416-D002) and also apply vacuum come the system. View Fig. 8 . This will certainly pull out any extra liquid trapped in the system and direct it right into the container.Allow the fluid to drain.

See more: How Long Does It Take To Boil A Gallon Of Water ? How Long Does It Take To Boil Water

When the liquid comes out together a thin stream or drip, the fluid is at the exactly level. Reinstall the little (center) liquid level describe plug making use of a 3/16" Allen key